KitchenAid 20.8 Cu. Ft. 36" Width Built In Panel Ready French Door Refrigerator インストールガイド

2. Place pieces of the shipping carton on the floor when rolling 

the dolly and refrigerator into the house. Move the refrigerator 
close to the built-in opening.

3. Place top of cardboard carton or plywood under refrigerator. 

4. Stand the refrigerator up. First, place the left bottom edge of 

the refrigerator on the floor, stand the refrigerator upright and 
then lower the right-hand side of the refrigerator to the floor.

5. Do not remove film or cover. 

6. Reassemble the trim and top grille after the dolly has been 

removed from the refrigerator.

Install Anti-Tip Boards

■

To avoid tipping during use, the solid soffit must be within 
1" (2.5 cm) maximum above the refrigerator. If the solid soffit 
is higher than 1" (2.5 cm) or one is not available, then the 
refrigerator must be braced. 

■

It is recommended that board(s) be installed before the 
refrigerator is installed.

■

Board(s) must be long enough to fully cover the width of the 
compressor cover.

■

Locate the board(s) so the bottom surface(s) of the board(s) is 
(are) 84" (213 cm) from the floor.

■

During installation, raise the refrigerator up so there is 

¹⁄₄" (6.35 mm) maximum between the top of the refrigerator 
and the bottom of the anti-tip board(s). Do not crush the 
compressor cover when raising the rear leveling legs.

NOTE: The foam gasket, on top of the compressor cover, will 
compress to fit under the anti-tip board(s). There is no need 
to trim the gasket.  

1. Mark the stud locations on rear wall.

2. Securely attach one or two 2" x 4" x 32" (5 cm x 10 cm x 

81 cm) boards to wall studs behind refrigerator. Use six 
#8 x 3" (7.6 cm) (or longer) wood screws. The wood screws 
must be screwed into the studs at least 1½" (3.8 cm). The 
board(s) must overlap the compressor cover.

Connect the Water Supply

Read all directions before you begin.

IMPORTANT: If you turn the refrigerator on before the water line 
is connected, turn the ice maker OFF.

■

Minimum 7 ft (2.13 m) flexible, codes-approved water 
supply line

NOTE: If your water line connection does not look like Style 1, 
see “Style 2—Copper Line Connection.”

1. Unplug refrigerator or disconnect power supply.

■

There is not enough clearance to achieve a flush installation 
if a water shutoff valve is located in the wall behind the 
refrigerator. The water shutoff should be located in the base 
cabinet on either side of the refrigerator.

■

Before attaching the tubing to shutoff valve, flush the main 
water supply line to remove particles and air in the water line. 
Allow enough flow so that water becomes clear. Flushing the 
water line may help avoid filters and/or water valves from 
becoming clogged. 

¹⁄₄

B

A

C

D