Netgear FS728TS - ProSAFE 24 Port 10/100 Stackable Smart Switch with 4 Gigabit Ports インストールガイド

Getting Started with Switch Management

1-5

8. Use your web browser to manage your switch. The default password is password. Then use 

this screen to proceed to management of the switch covered in 

.

This section describes how to set up your switch in a network without a DHCP server, and is 
divided into the following tasks:

•

Manually assign network parameters for your switch

•

Configure the NIC settings on the host PC

•

Log in to the web-based switch management utility

If your network has no DHCP service, you must assign a static IP address to your switch. You can 
also assign the switch a static IP address even if your network has DHCP service. Proceed as 
follows:

1. Connect the FS700TS 10/100 Stackable Smart Switch with Gigabit Ports to your existing 

network.

2. Power on the switch by plugging in the AC-DC power adapter. The default IP is 

192.168.0.239. 

3. Install the SmartWizard Discovery utility on your computer. The SmartWizard Discovery 

utility is located on the switch installation CD.

4. Start the SmartWizard Discovery utility.

5. Click Discover for the SmartWizard Discovery utility to find your FS700TS 10/100 Stackable 

Smart Switch with Gigabit Ports. You should see a screen similar to that shown in Figure 1-1.

6. Click Configuration Setting. A screen similar to that shown below appears.