Netgear FS728TS - ProSAFE 24 Port 10/100 Stackable Smart Switch with 4 Gigabit Ports インストールガイド

1-8

Getting Started with Switch Management

You must work from the same network segment that contains the switch (i.e., the subnet mask 
values of switch and PC host must be the same) and you must point your browser using the switch 
IP address. If you used the SmartWizard Discovery utility to set up IP address and subnet mask, 
either with or without DHCP server, use that IP address in your browser window. 

If you are starting with an “out of the box” switch and are not using the SmartWizard Discovery 
utility, you must initially configure your host PC to be on a network segment to match the default 
parameters of the switch, which are:

•

IP address: 192.168.0.239

•

Subnet Mask: 255.255.255.0

You can change the network parameters to match those of your network (this procedure is 
described in 

). Your host PC network parameters must 

then be set to match your network.

Clicking Web Access on the SmartWizard Discovery utility or accessing the switch directly 
displays the screen shown below.

. 

Use this screen to proceed to management of the switch covered in 

.

Alternatively, from the main screen shown on Figure 1-1 you can access these additional 
functions:

•

•