Netgear FS728TS - ProSAFE 24 Port 10/100 Stackable Smart Switch with 4 Gigabit Ports インストールガイド
FS700TS Smart Switch Software Administration Manual
Managing System Settings
3-15
v1.0, September 2007
–
Force Master – Force the selection of a stack master. Note that only Unit 1 or Unit 2
can be the stack master.
can be the stack master.
•
Stacking Ports After Reset – Select the type of port used in the stack. The possible field
values are:
values are:
–
Combo Ports – The combo port is used as the stacking port.
–
Copper Ports – The copper port is used as the stacking port.
2. Select the Master Election mode.
3. If you selected Force Master, select either 1 or 2 from the stack ID list.
4. Select the type of Stacking Ports After Reset.
5. Click APPLY to update the device.
6. Reset the device for the new settings to take effect. See
for detailed instructions on
resetting the device.
Stack Management
To configure Stack Management:
1. Click System > Stacking > Advanced > Stack Management. The Stack Management screen
displays:
The Stack Management screen contains the following fields:
•
Unit No. – Displays the stacking member’s current number. Possible values are 1-6.
•
Unit No. After Reset – Select the stacking member’s future number after the device is
reset. The possible field values are:
reset. The possible field values are:
Figure 3-8