avolites pearl exper ttitan ユーザーズマニュアル

Page 104 – 9. Running the show

 

 

 

 

PearlExpertTitan_Man_v3.doc  29/03/2010 13:28:00 

active in another playback will not change when you use Preload). 

You can also allocate Go and Stop buttons for cue lists and chases. To 

quickly change the key profile, hold Avo Shift and press C [Edit Key 

Profile]. 
The Touch Wing playbacks display 

shows the allocated function of the 

blue and grey buttons on the 

playbacks. 
 

You can set playbacks to high priority if you do not want them to be 

overridden by other playbacks using the same fixtures. For example, 

if you have a couple of fixtures acting as a spotlight, but they are also 

programmed into some colour washes, you probably want the 

spotlight cue to take priority over the colour washes. See section 

If you have not had as much programming time as you would have 

liked, you might need to make up some additional effects during the 

show. This is sometimes called “busking”, and is where the fun starts!  
You can create instant variations by recalling palette values to modify 

your existing cues. The Pearl can fade to the palette values for added 

effect. 

 

When a fade is entered, you can also change the “Fixture Overlap” 

using softkey A. This allows you to create “roll” or “peel” effects when 

using a series of fixtures. With overlap=100%, all fixtures change at the 

same time. If overlap=50%, the second fixture will not start its fade 

until the first fixture is half way (50%) through fading. The order of the 

fixtures is set by the order in which you selected them. 

The fade remains active while the Palette Fade menu is open. Press 

Exit to leave the menu to stop fading. 
If you apply a palette with a fade time, then it will be overridden by 

the next cue (so if you fade to green using a palette, then fire a cue 

which sets those fixtures blue, they will go blue). If you apply a 

palette without a fade time, it will go into the programmer and 

override any subsequent cues (so if you use a green palette with no 

fade, the fixtures will be locked in green until you press Clear). 
Having the palette overridden by the next cue is quite useful when 

“busking”. If you need to “snap” a palette but still have it overridden 

by the next cue, set a fade time of 0 (leaving the Palette fade menu 

open).