avolites pearl exper ttitan ユーザーズマニュアル
Copyright Avolites Limited 2010
Page 134 – 13. Networking
PearlExpertTitan_Man_v3.doc 29/03/2010 13:28:00
13.2.1 Setup DMX outputs screen
On the left hand side of the screen, the 12 DMX lines generated by
the Pearl are shown. On the right hand side is a list of nodes where
the DMX can be routed to.
As an example we will add an ACDI node to DMX Line 1.
1> On the Pearl Titan application menu, click on Tools, Setup DMX
Outputs. (Use Switch Task on the Tools menu to bring the Pearl
Titan application to the front)
2> Click on Settings
3> Select the ACDI module.
4> Ensure that the correct Network adapter is set (this may not be
3> Select the ACDI module.
4> Ensure that the correct Network adapter is set (this may not be
the Default Adapter) and the Enable DMX Output box is ticked
5> Click
OK
6> In the left panel, select a DMX line for the simulator
7> In the right panel, select the ACDI Ethernet node that you want
7> In the right panel, select the ACDI Ethernet node that you want
to connect to
8> Click on Add Node. This will add an ACDI node to that DMX
output
9> On the left hand side, select the node you have added. The
node properties will be shown in the panel on the bottom right
of the window
To remove a node from a DMX line, select the node (i.e. Broadcast 2)
and click Remove Node.
Each DMX line can be sent to multiple nodes (this will effectively
Each DMX line can be sent to multiple nodes (this will effectively
create a duplicate DMX universe). However you must ensure that you
do not send more than one DMX line to a single node, as this can
cause problems.
13.3
ArtNet
Art Net is an open standard for transmitting Lighting information over