avolites pearl exper ttitan ユーザーズマニュアル
Copyright Avolites Limited 2010
Page 136 – 13. Networking
PearlExpertTitan_Man_v3.doc 29/03/2010 13:28:00
• Line B to Box 1 universe 2
• Line C to Box 2 universe 2 and the dimmer rack
• Line C to Box 2 universe 2 and the dimmer rack
13.3.2 Setting up an ArtNet system
For this example, it is assumed that you will connect the Pearl to an
Art Net DMX output box (such as an Artistic License Net-Lynx) via a
network hub.
Using standard network cables, attach the devices together.
If you are using a hub/switch as shown above, use straight-through
If you are using a hub/switch as shown above, use straight-through
cables. If you are directly connecting the Pearl to another Ethernet
device you need to use crossover cables
Set the Net-Lynx box as follows:
Set the Net-Lynx box as follows:
• Subnet Mask = 0
• DMX A Universe = 1
• DMX B Universe = 2
• DMX A Universe = 1
• DMX B Universe = 2
A lot of Art-Net devices, including the Net-Lynx box, are set to IP
address 2.x.x.x as default, and can be set to 10.x.x.x using an option
jumper, so you should check what the setting of your device is.
If your ArtNet devices need to be set to a non-standard IP address,
If your ArtNet devices need to be set to a non-standard IP address,
then in steps 1 and 2 you need to use Windows Control Panel to set
the Pearl to that address range instead of 2.x.x.x
With everything connected, start the Pearl.
With everything connected, start the Pearl.
1> Ensure the Pearl has an IP in the 2.x.x.x range as described at
the start of the chapter.
2> On the Pearl VDU, click on Tools, Setup DMX outputs.
3> Click on settings
3> Click on settings