avolites pearl exper ttitan ユーザーズマニュアル
Copyright Avolites Limited 2010
Page 40 – 3. Controlling dimmers and fixtures
PearlExpertTitan_Man_v3.doc 29/03/2010 13:28:00
can set the LED in the Select button to mimic brightness rather
•
You can select fixtures on another page by pressing one of the
Pages of Fixtures buttons (above the numeric keys). Palettes,
groups and any cues you have saved on the preset faders will
also change with the fixture page.
•
On the Touch Wing, you can view more fixture buttons either by
using the scroll slider on the right of the window, or if you have
enabled Page buttons using the [Pages Show/Hide] context
button, by using the Page touch buttons.
•
If a preset is active (the fader is raised) when you change page,
you may want to control a fixture on the new page using the
same preset. In this situation you have to match the fader level
to the existing fixture level before the fader will take control.
For example if preset 1 is on at 100%, you change to page 2
and want to control the fixture on preset 1 on page 2. If the
page 2 fixture is currently Off, you will have to lower the fader
to zero before it takes control. If the page 2 fixture is at 50%,
the fader will take control when it matches the 50% value.
3.1.2
Setting fixtures to a start position
The Locate button (the red button on the bottom right of the
console) is used to put the fixture into a known position with light
coming out, so that you can start programming it.
A quick press of the button will move all selected fixtures to a central
A quick press of the button will move all selected fixtures to a central
position and reset all the attributes so that you get a white light.
However you sometimes might not want to move the fixture, and by
holding down the Locate button, you get some more options.
•
You can mask off some of the Locate settings (such as only
turning the fixture on, but not changing its position or colour)
by holding down Locate and pressing [Set Mask to Exclude All].
Then (still holding Locate) turn on the Attributes you want to
change using the Attribute Bank buttons down the right hand
side. Only the lit attributes will be changed by Locate. Pressing
the Attribute Options (Bank Select) button will clear the mask.
•
[Auto Reset Mask] sets the mask to be automatically reset to
include everything each time Locate is pressed, or you can
Scroll slider