Mitel Deutschland GmbH 68635RFP36U-01 ユーザーズマニュアル
OM Management Portal (OMP)
167
“WLAN” tab
Settings in the
Settings in the
WLAN tab apply to RFPs of the type “RFP 42 WLAN” and “RFP 43 WLAN” only. For
details about WLAN configurations please see section 7.18.
Please note:
WLAN properties can only be set if the correct hardware type is configured in
the
Hardware tab.
•
WLAN switched on: The WLAN functionality for an RFP 42 WLAN or an RFP 43 WLAN can be
switched on/off.
•
For a description of the other parameters which can be set in the
WLAN tab, see the description of
the
DECT base stations page of the OMM Web service (see section 5.6.3). The corresponding
parameters can be found there in the
WLAN settings section.
Note: Configuration of WLAN profiles is only possible with the OM Web
service, see section 5.8.1.
“Hardware” tab
WLAN properties can only be set if the correct hardware type is configured. This can be done manually
before an RFP connects with the OMM and an automatic detection is possible (
WLAN properties can only be set if the correct hardware type is configured. This can be done manually
before an RFP connects with the OMM and an automatic detection is possible (
Auto setting).
6.7.1.3 Changing DECT base station configuration
Changing RFPs is only possible in
Changing RFPs is only possible in
configuration mode. To change the configuration of an existing
RFP, do the following:
1 Select the appropriate RFP in the RFP table.
2 Click Configure under the Tasks lists on the right side of the DECT base stations window.
1 Select the appropriate RFP in the RFP table.
2 Click Configure under the Tasks lists on the right side of the DECT base stations window.
The DECT base station detail panel opens.
3 Change RFP parameters (see descriptions in section 6.7.1.2).
4 Click OK.
4 Click OK.
6.7.1.4 Viewing DECT base station Details
You can view the configuration of an RFP in
You can view the configuration of an RFP in
Monitor Mode. Proceed as follows:
1 Select the appropriate RFP in the RFP table.
2 Click Show details under the Tasks lists on the right side of the DECT base stations window.
2 Click Show details under the Tasks lists on the right side of the DECT base stations window.
The DECT base station detail panel opens.
3 To close the RFP detail panel, click Cancel.
6.7.1.5 Deleting DECT base stations
Deleting RFPs is only possible in
Deleting RFPs is only possible in
Configuration Mode. To delete an existing RFP, do the following:
1 Select the appropriate RFP(s) in the RFP table by activating the corresponding checkbox(es).
2 Click Delete under the Tasks lists on the right side of the DECT base stations window.
2 Click Delete under the Tasks lists on the right side of the DECT base stations window.
The
Delete selected DECT base station(s) dialog opens showing a confirmation prompt.
3 Click OK to confirm.