Geophysical Survey Systems Inc. 270LL3P ユーザーズマニュアル
User Guide
LifeLocator
®
III+ System
Section 1: Getting Started
1.
Insert a fully charged battery into the battery slot in the back of the Sensor and close the
cover.
cover.
When connected
• Make sure the Control Unit (PDA) is fully charged.
• If not already properly set, go to Start > Settings > System > Clock & Alarms to
• If not already properly set, go to Start > Settings > System > Clock & Alarms to
set the correct time and date on the Control Unit.
2.
Switch the Sensor power button to the ON position and push the Control Unit green
power button. On the Sensor, the
power button. On the Sensor, the
blue
power light appears followed, about 45 seconds
later, by a flashing
red
light when wireless is ready.
will say LFGSSIAH
3.
On the control Unit (Windows Mobile screen), make sure that LFGSSIAH appears next
to WLAN below the date and time.
to WLAN below the date and time.
• If it says Off, tap WLAN, then Wireless LAN on the next screen.
Make sure that Bluetooth is Off. When LFGSSIAH appears, press ok on the keypad to return to the Windows
Mobile screen .
Mobile screen .
4.
To run the LL3 software press the Windows flag logo button á on the Control Unit or go to Start > LL3. The
MAIN menu appears. At the bottom of the screen, notice a small square moving back and forth. Wait for a few
seconds for it to turn from red to green, indicating that the Control Unit is ready to communicate with the Sensor.
MAIN menu appears. At the bottom of the screen, notice a small square moving back and forth. Wait for a few
seconds for it to turn from red to green, indicating that the Control Unit is ready to communicate with the Sensor.
5.
If the ID number (ex., 001) that appears in the CONNECT TO box matches the ID number
of the Sensor being used, press the Enter button on the Control Unit or tap RUN. The
target screen appears and the run clock at the bottom right starts incrementing. The
filename is indicated in the upper right portion of the Control Unit screen.
of the Sensor being used, press the Enter button on the Control Unit or tap RUN. The
target screen appears and the run clock at the bottom right starts incrementing. The
filename is indicated in the upper right portion of the Control Unit screen.
Red
circles
(breathing) and black squares (motion) may be seen and grow larger as detection
confidence improves. The approximate distance of the detected motion is indicated on the
left margin of the screen.
confidence improves. The approximate distance of the detected motion is indicated on the
left margin of the screen.
• The appearance of both battery status indicators at the bottom of the screen (thin
indicator for PDA, wide indicator for Sensor) indicates successful communication
between the Control Unit and Sensor.
between the Control Unit and Sensor.
• Keypad buttons can control nearly all functions.
• Pressing ok on the Control Unit quits to a previous screen. From the MAIN menu, it
• Pressing ok on the Control Unit quits to a previous screen. From the MAIN menu, it
quits to the Windows Mobile screen. Pressing the green power button on the Control
Unit turns the PDA off. Do this only from Windows Mobile, not while in the
LifeLocator software.
Unit turns the PDA off. Do this only from Windows Mobile, not while in the
LifeLocator software.
• Control Unit backlight may be increased/decreased by use of the PDA's Left and Right
arrow buttons.
• To conclude a search press STOP on the Control Unit screen or the ok button.
UltraVision Security Systems, Inc.
3
Copyright © 2009 All Rights Reserved