Geophysical Survey Systems Inc. 270LL3P ユーザーズマニュアル
User Guide
LifeLocator
®
III+ System
Additional Details
1.
If it is necessary to set the Sensor number for the Control Unit to connect to, access the Maintenance screen by
tapping MAINTENANCE on the Control Unit screen three times (hear three beeps) or use the Up/Down arrows to
highlight Maintenance then press Enter three times. Tap Yes on the screen when the dialog box appears confirming
Maintenance Operation. The Sensor ID number can be found on the white label affixed to the Sensor.
tapping MAINTENANCE on the Control Unit screen three times (hear three beeps) or use the Up/Down arrows to
highlight Maintenance then press Enter three times. Tap Yes on the screen when the dialog box appears confirming
Maintenance Operation. The Sensor ID number can be found on the white label affixed to the Sensor.
• Use either the Control Unit Up/Down arrows to highlight it or tap ANTENNA on the screen. Using the Left/Right
arrows, highlight the first digit. Then using the Up/Down arrows, increment (down) or decrement (up) as needed.
• Using the Left/Right arrows repeat the above procedure for the second and third Sensor ID digit. When finished,
press ok on the Control Unit or tap ok on the PDA screen to return to the MAIN menu.
• If the CONNECT TO box is not checked on the MAIN menu and RUN is selected, a Select Antenna screen will
appear showing all WiFi antennas in the area. Check the appropriate box next to the chosen Sensor, and then press
Select on the Control Unit screen. A search cycle will begin immediately. Pressing ok on the Control Unit will
send you back to the MAIN menu.
Select on the Control Unit screen. A search cycle will begin immediately. Pressing ok on the Control Unit will
send you back to the MAIN menu.
2.
The
red
,
green
and
blue
LEDs on the sensor illuminate when communication is established. You will see a screen
like the one on the following page. The two power indicators and the incrementing timer/clock also indicates that the
system is working and that communication is established.
system is working and that communication is established.
Note: If a dialog box saying Radar Time Out appears, (1) exit out of the LifeLocator program, (2) turn the sensor
OFF then ON and (3) rerun LifeLocator.
OFF then ON and (3) rerun LifeLocator.
• The program will look for both breathing and motion. Motion above the alarm threshold produces a black
square. Breathing above threshold produces
red
concentric circles. Sustained motion or breathing will result in
larger squares or circles.
• A flashing ANTENNA box means that you have lost WiFi communication. Try to move closer within
10 seconds to recover.
Stop: Tap STOP only once. Tapping twice resumes the search. Tap ok to MAIN LifeLocator menu or press the
Enter button.
Enter button.
UltraVision Security Systems, Inc.
4
Copyright © 2009 All Rights Reserved