Geophysical Survey Systems Inc. 270LL3P ユーザーズマニュアル
User Guide
LifeLocator
®
III+ System
Appendix A: Battery Use
Viewing window
1.
Checking Sensor Battery Life: There is a viewing window on the end of the battery near the pull tab. Columns
indicate the status of the battery: 5 columns – 100%, 4 columns 80%, 3 columns 60%, 2 columns 40%, 1 column
20% or less. Batteries showing 1 or 2 columns should be fully charged prior to use. Recharge time takes about
2 hours.
indicate the status of the battery: 5 columns – 100%, 4 columns 80%, 3 columns 60%, 2 columns 40%, 1 column
20% or less. Batteries showing 1 or 2 columns should be fully charged prior to use. Recharge time takes about
2 hours.
2.
Recharging Sensor Battery: To recharge a battery, insert it into the charger. Make sure that the ends align correctly
into the slot.
into the slot.
3.
Recharging Control Unit: Recharging the Control Unit Battery: To recharge the Control Unit (PDA), insert the
charging cord into the bottom of the Control Unit. Then plug the charger in. The wall charger is supplied with plug
ends for all international sources of power. (Use only the manufacturers supplied charger.) A vehicle charger cord
for the Control Unit is also supplied. When using the AA battery unit, be sure to use high quality, high mAh
capacity alkaline batteries. To remove the stock Li-ion battery and replace it with the AA battery unit, remove the
four screws holding the battery pack with one end of the supplied PDA stylus.
charging cord into the bottom of the Control Unit. Then plug the charger in. The wall charger is supplied with plug
ends for all international sources of power. (Use only the manufacturers supplied charger.) A vehicle charger cord
for the Control Unit is also supplied. When using the AA battery unit, be sure to use high quality, high mAh
capacity alkaline batteries. To remove the stock Li-ion battery and replace it with the AA battery unit, remove the
four screws holding the battery pack with one end of the supplied PDA stylus.
Appendix B: File Maintenance
1.
Downloading Files: Initially all search data files are stored on the Sensor. To transfer them to the
Control Unit, you must first download them from the Sensor. To download a file:
Control Unit, you must first download them from the Sensor. To download a file:
1.
Select MAINTENANCE from the Main menu by tapping it three times and answering Yes
to the pop up dialog box.
to the pop up dialog box.
2.
Select DOWNLOAD DATA FILE.
3.
Check the desired files or select SELECT ALL then DOWNLOAD. This may take a few
moments depending on the size and number of files selected.
moments depending on the size and number of files selected.
2.
Transfer/Export Files to Laptop/Desktop: To see files on the Control Unit (PDA), exit the
LifeLocator program.
LifeLocator program.
1. Tap Start > File Explorer.
2. Go to the file path My Device > LL3 > Download.
3. You will then need to transfer chosen files via ActiveSync through a USB cable to you
2. Go to the file path My Device > LL3 > Download.
3. You will then need to transfer chosen files via ActiveSync through a USB cable to you
computer.
Note:
This procedure is required for manufacturer analysis of search data.
3.
Clear Storage: To delete files from Sensor storage after an exercise or many months of use in
training, make sure the Control Unit and Sensor are communicating.
training, make sure the Control Unit and Sensor are communicating.
1.
Select Clear Storage from within the MAINTENANCE menu.
2.
Select the file(s) you wish to delete or Select All.
3.
Select Delete. When done the Control Unit
will return to the MAINTENANCE menu.
UltraVision Security Systems, Inc.
7
Copyright © 2009 All Rights Reserved