Geophysical Survey Systems Inc. 270LL3P ユーザーズマニュアル

User Guide

LifeLocator

III+ System

Section 3: Expert Mode

Access the Expert Mode from the Main menu by using the Up/Down arrows to highlight EXPERT MODE then press the
Enter button or simply tap EXPERT MODE on the Control Unit screen.

WAVEFORM is a diagnostic screen. A properly functioning Sensor should show a waveform pattern (see below).

LINESCAN enables viewing radar data results in real time that may indicate breathing or motion as an alternative to the
basic Run screen (squares and circles). The screen is rotated 90 degrees in order to display data more effectively. The
margin on the right displays the approximate distance of any motion signals. The margin on the left permits several user
selected options:

• RESTART: terminates current search cycle and starts

another.

• COLOR: a display palette of five colors patterns are

available. Typically number 3 and 4 give best results.

• GAIN: may be adjusted from 1 to 256 depending on the

make up of the material being searched. Best results are
normally obtained at settings no higher than 32.

• LIGHT: the intensity of the backlight can be

increased/decreased.

Expert Mode – Target Playback

While in the Expert Mode, previous search cycles may be played back showing radar

data

collected at the time. From the Expert Mode screen, use the Up/Down arrows on the

Control

Unit to highlight Playback Data or simply tap PLAYBACK DATA on the Control

Unit

screen.

As in normal Playback Mode, the SELECT FILE screen appears. Highlight or tap the

chosen

search file.

• Similar to the normal Playback Mode, RESTART, COLOR, and GAIN are user

selectable choices. An additional choice allows the user to control the speed of
playback from

(slowest) to 5 (fastest).

• Search files performed in normal mode (circles and squares) but later

played back in Expert Mode have the ability to display the circle or
square icons overlaid on the radar data if
Target Playback (a choice on the left margin) is turned on. Search
files performed under Expert Mode cannot show the icons and the
Target On button will be grayed out.

• To return to the Expert Mode menu press OK. To return to the MAIN

menu, press ok once again.

UltraVision Security Systems, Inc.