Microwave Radio Communications LLC CR2TX2AD ユーザーズマニュアル
Routine Operation
3-7
CodeRunner 2 Operator’s Guide/Tech Ref Manual
3.6
Frequently Performed Tasks
This chapter describes how to perform many common tasks with
the CodeRunner 2. Here are the tasks described:
the CodeRunner 2. Here are the tasks described:
Refer to the Main Screen display in Figure 3-3, and the menu
maps in Figure 3-4 and Figure 3-5 to follow along with these
instructions.
maps in Figure 3-4 and Figure 3-5 to follow along with these
instructions.
Topic
Page
3.6.1
Turning the power ON and OFF
1.
Open the front panel of the Indoor Unit by loosening
the 2 large screws and letting the panel swing down.
the 2 large screws and letting the panel swing down.
2.
Press the Power switch.
3.
Close the front panel by swinging it up and tightening
the two screws.
the two screws.
3.6.2
Activating and deactivating the transmitter
1.
Make sure the power to the CodeRunner 2 is on.
2.
On the Main Screen,
-
To activate the transmitter: press
PA
until the Status
Area displays
XMIT
.
-
To deactivate the transmitter: press
PA
until the Status
Area displays
STDBY.
3.6.3
Switching between HI and LOW power
1.
Make sure the power to the CodeRunner 2 is on.
2.
On the Main Screen,
-
To switch the transmitter to High power: press
Hi/Lo
until the Status Area displays
High
.
-
To switch the transmitter to Low power: press
Hi/Lo
until the Status Area displays
LOW
.