Elitegroup 945GCT-M3 ユーザーズマニュアル
45
Using BIOS
Init Display First (PCI Slot)
This item allows you to choose the primary display card.
Reset Configuration Data (Disabled)
If you enable this item and restart the system, any Plug and Play configuration data
stored in the BIOS Setup is cleared from memory.
stored in the BIOS Setup is cleared from memory.
Resources Controlled By Auto (Auto (ESCD))
You should leave this item at the default Auto (ESCD). Under this setting, the system
dynamically allocates resources to Plug and Play devices as they are required.
dynamically allocates resources to Plug and Play devices as they are required.
If you cannot get a legacy ISA (Industry Standard Architecture) expansion card to
work properly, you might be able to solve the problem by changing this item to
Manual, and then opening up the IRQ Resources submenu.
work properly, you might be able to solve the problem by changing this item to
Manual, and then opening up the IRQ Resources submenu.
Length to set the amount of reserved memory. Press <Esc> to close
the Memory Resources submenu.
PCI/VGA Palette Snoop (Disabled)
This item is designed to overcome problems that can be caused by some non-standard
VGA cards. This board includes a built-in VGA system that does not require palette
VGA cards. This board includes a built-in VGA system that does not require palette
snooping so you must leave this item disabled.
INT Pin 1-8 Assignment (Auto)
Identifies the interrupt request (IRQ) line assigned to a device connected to the PCI
interface of your system.
interface of your system.
Maximum Payload Size (4096)
This item specifies the maximum TLP payload size for the PCI Express devices.
The unit is byte.
The unit is byte.
PC Health Status
On motherboards that support hardware monitoring, this item lets you monitor
the parameters for critical voltages, temperatures and fan speeds.
the parameters for critical voltages, temperatures and fan speeds.
•
IRQ Resources:In the IRQ Resources submenu, if you assign an IRQ
to Legacy ISA, then that Interrupt Request Line is reserved for a legacy
ISA expansion card. Press <Esc> to close the IRQ Resources submenu.
ISA expansion card. Press <Esc> to close the IRQ Resources submenu.
In the Memory Resources submenu, use the first item Reserved Memory
Base to set the start address of the memory you want to reserve for
the ISA expansion card. Use the section item Reserved Memory
the ISA expansion card. Use the section item Reserved Memory
Phoenix-AwardBIOS CMOS Setup Utility
PC Health Status
Shutdown Temperature
[Disabled]
Vcore (V)
5VSB (V)
+3.3V
+5V
+12V
VBT(V)
Current System Temp
Current CPU Temperature
Current System Fan Speed
Current CPU Fan Speed
Current CHS Fan Speed
5VSB (V)
+3.3V
+5V
+12V
VBT(V)
Current System Temp
Current CPU Temperature
Current System Fan Speed
Current CPU Fan Speed
Current CHS Fan Speed
Item Help
Menu Level
: Move Enter: Select +/-/PU/PD:Value F10:Save ESC:Exit F1: General Help
F5:Previous Values F6:Fail-Safe Defaults F7:Optimized Defaults