Sterling Home Theater Server XXX10-80 ユーザーズマニュアル
10-Pump, 80-Station Controller
Chapter 4: Operation
53
2. Touch anywhere in the rectangle in the upper right of the screen or the Help button
on the lower right side of the screen.
The Help Menu appears.
3. In the section of the Help Menu labeled Screen Symbols/Colors, touch Pump.
The Pump Symbols help screen appears, explaining the status represented by each
color.
color.
4. When you are finished reviewing the information, touch Pumps (or Stations).
The Pump Status (or Station Status) screen appears.
The following table explains the status represented by each color at the Pump Status screen.
Color Label Description
Silver
Silver
Offline
Pump is not enabled. The controller ignores any alarms.
Blue
Ready
Pump is off, waiting for demand from a station.
Light Green
Idle
Pump is on, waiting for demand from a station. If there is no
demand before the end of the auto shutdown delay, the pump
will turn off.
demand before the end of the auto shutdown delay, the pump
will turn off.
Green
Loading
Pump is conveying material to a station.
White
Cleaning
Pump’s air filter is being cleaned by blowing compressed air
backward through it.
backward through it.
Orange
Alarm
Pump is in alarm.
Red
Critical
Pump is in critical alarm. The controller has disabled the pump
until the alarm is cleared.
until the alarm is cleared.
Light Yellow
Waiting
Pump is waiting for material to become available.
Additional information about each pump, including configuration settings and the number of
hours the pump has been running, is available at the Pump n Setup screen. For details on
configuration settings, see page 42. For details on the hour meter, see page 58.
hours the pump has been running, is available at the Pump n Setup screen. For details on
configuration settings, see page 42. For details on the hour meter, see page 58.
Logging On and Logging Off
Your controller may be set up to require a password for any operation (other than reviewing
station and pump status, silencing alarms, reviewing the alarm log, and looking at help
screens). If so, a password entry screen will appear:
Your controller may be set up to require a password for any operation (other than reviewing
station and pump status, silencing alarms, reviewing the alarm log, and looking at help
screens). If so, a password entry screen will appear:
Press the Enter Password button. A keypad will appear: