Sterling Home Theater Server XXX10-80 ユーザーズマニュアル

10-Pump, 80-Station Controller 

Chapter 4: Operation 

55 

The 10/80 Controller has a Station Operator Settings screen for each station, as shown below. 
This screen enables you to review and adjust all basic settings for the station. 

To reach the Station n Operator screen: 

1.  Go to the Station Status screen, if needed. 

To reach this screen from any other screen, touch Stations on the right-hand side 
of the screen. 

2.  Touch and hold the icon for the station, until the controller either prompts for the 

password or displays the Station n Operator screen. 

Once you have entered the password (if needed), the Station n Operator screen 
appears: 

 

 

Settings in the box labeled Convey, the red Priority Convey Activate button, and 
the menu controls on the right-hand side of the screen appear for all stations. The other 
options in this screen appear if and only if the station has these features enabled. 

Buttons in light gray are settings that you can adjust at this screen. Boxes in dark gray are for 
display only. If a pump assignment or purge setting needs to be changed, this must be done at 
the Station n Setup screen. 

The controls in the upper right-hand corner of the screen enable you to move among the 
Station Operator screens: 

1.  To display the screen for the next lower-numbered station (for example, to move 

from the screen for Station 15 to the screen for Station 14), touch ◄ Back. 

2.  To display the screen for the next higher-numbered station (for example, to move 

from the screen for Station 15 to the screen for Station 16), touch Next ►. 

3.  To display the screen for a specific station, touch Goto. A keypad pops up. Enter the 

number for the desired station. Use 

← to erase any mistakes. Use ↵ to enter the 

value. 

4.  To exit to the Station Status (or Pump Status) screen, touch Stations (or Pumps).