Manualsbrain.com
  1. マニュアル
  2. ブランド
  3. Sentry Industries
  4. PT22
  5. ユーザーズマニュアル

Sentry Industries PT22 ユーザーズマニュアル

ダウンロード
ページ / 74
Displaying network configuration information 
The Show Network command displays TCP/IP, Telnet, SSH, Web, SSL and SNMP configuration information.  
•  IP address, subnet mask, gateway and DNS IP addresses 
•  Enabled-disabled status and port numbers for Telnet, SSH, HTTP,SSL and SNMP support 
•  HTTP authentication method and SSL access setting 
•  Network status 
See Chapter 4: Advanced Operations on page 45 for more information on SNMP and Remote 
Authentication 
To display network configuration information: 
At the Sentry: prompt, type show network and press Enter. 
Example 
The following command displays the network configuration information: 
Sentry: show network<Enter> 
   Network Configuration 
      IP Address:    12.34.56.78                   DNS1: 98.76.54.254 
      Subnet Mask:   255.0.0.0                     DNS2: 0.0.0.0 
      Gateway:       12.34.56.1 
      Telnet:        Enabled       Port:    23 
      SSH:           Enabled       Port: 65535 
      HTTP:          Enabled       Port:    80     Security: BASIC 
      SSL:           Enabled                       Access:   Required 
      SNMP:          Enabled 
   Network Status 
      Link:          Up 
      Speed:         100 Mbps 
      Duplex:        Full 
      Negotiation:   Auto 
HTTP Administration 
NOTE:  A restart is required after setting or changing ANY Telnet/Web configurations.  See Performing a warm boot on 
page 38 for more information.  
Enabling and disabling HTTP support 
The Set HTTP command is used to enable or disable HTTP support. 
To enable or disable HTTP support: 
At the Sentry: prompt, type set http, followed by enabled or disabled and press Enter. 
Changing the HTTP server port 
With HTTP support enabled, the HTTP server watches and responds to requests on the default HTTP port 
number 80.  This port number may be changed using the Set HTTP Port command.  
To change the HTTP port: 
At the Sentry: prompt, type set http port, followed by the port number and press Enter. 
Example 
The following changes the HTTP port number to 2048: 
Sentry: set HTTP port 2048<Enter> 
Setting the HTTP authentication method 
The Set HTTP Security command is used to set the method of authentication.  The Sentry HTTP server 
supports two authentication methods for security and validation of the username-password – Basic and MD5 
digest. 
For more information on authentication methods, see Setting the HTTP authentication method: on page 14. 
To set the HTTP authentication method: 
At the Sentry: prompt, type set http security, followed by basic or md5 and press Enter. 
40 
•   Operations 
Sentry PT22 
 
 
 
Installation and Operations Manual