Sentry Industries PT22 ユーザーズマニュアル
Setting the trap timer
The Set Traptime command sets the timer period between repeated error-condition traps. The valid
range for the timer period is 1 to 65535 (in seconds).
The default value for the timer period is 60 seconds.
range for the timer period is 1 to 65535 (in seconds).
The default value for the timer period is 60 seconds.
To set the trap timer:
At the Sentry: prompt, type set traptime, followed by the timer period and press Enter.
Example
The following sets the timer period to 180 seconds:
Sentry: set traptime 180<Enter>
Setting the Get/Set community strings
Sentry supports two SNMP community strings that provide varying levels of access to objects defined
in the Sentry3 MIB.
in the Sentry3 MIB.
Community strings may be 1 to 24 characters.
Setcomm
The Setcomm string provides read-write access to sentry3 MIB objects.
The default Setcomm string is “private”
The default Setcomm string is “private”
To set the Setcomm community string:
At the Sentry: prompt, type set snmp setcomm, followed by the string and press Enter.
Getcomm
The Getcomm string provides read-only access to sentry3 MIB objects.
The default Getcomm string is “public”.
The default Getcomm string is “public”.
To set the Getcomm community string:
At the Sentry: prompt, type set snmp getcomm, followed by the string and press Enter.
Setting the Trap community string
The Set SNMP Trapcomm command is used to set the community string that is included with all
generated traps. This string must be defined to enable trap generation.
generated traps. This string must be defined to enable trap generation.
The trap community string may be 1 to 24 characters.
The default Trapcomm string is “trap”.
The default Trapcomm string is “trap”.
To set the Trapcomm community string:
At the Sentry: prompt, type set snmp trapcomm, followed by the string and press Enter.
Displaying SNMP configuration information
The Show SNMP command displays all SNMP configuration information.
• SNMP support status
• SNMP community strings
• Trap timer value
• Trap destinations
• Trap destinations
To display SNMP configuration information:
At the Sentry: prompt, type show snmp and press Enter.
Example
The following command displays the SNMP configuration information:
Sentry: show snmp<Enter>
SNMP Configuration
SNMP Configuration
Sentry PT22
Advanced Operations
• 49
SNMP: Enabled
SET Community String: private
GET Community String: public
TRAP Community String: trap
Error Trap Repeat Time (seconds): 180
Trap Destination 1: 64.42.31.208
Trap Destination 2: (undefined)
SET Community String: private
GET Community String: public
TRAP Community String: trap
Error Trap Repeat Time (seconds): 180
Trap Destination 1: 64.42.31.208
Trap Destination 2: (undefined)
Installation and Operations Manual