Novatel GNSS Receiver and Antenna SMART-AG ユーザーズマニュアル

Technical Specifications

Appendix A

SMART-AG User Manual Rev 2

• Serial data signals (TxD, RxD, signal ground) must be run in shielded cable.

Connect shields to ground at SMART-AG end only

• CAN signal conductors must be twisted (40 twists/m, 12 twists/ft)

• Use only the recommended mating connectors listed below. Use only gold plated

pins

WARNING:

Failure to observe the given cable construction guidelines in this section will
result in damage to the wiring (not covered by warranty).

The connector used in the SMART-AG is an “AMPSEAL” dust and water type produced by Tyco.
The following part numbers pertain to the mating connector required to make connections to the
SMART-AG. These numbers are provided for information only and are not available from NovAtel as
seperate parts.

Table 8: SMART-AG Mating Connectors

Table 9 details the part numbers for recommended fuses and fuse holders. These numbers are provided
for information only and are not available from NovAtel as seperate parts.

Product

Part Description

Company

Part Number

SMART-AG mating connector
(Figure 15 on Page 53)

14-pin sealed
receptacle housing-

black

Tyco/AMP

776273-1

SMART-AG mating connector
(Figure 15 on Page 53)

14-pin sealed
receptacle housing-
natural

Tyco/AMP

776273-2

SMART-AG mating connector

(Figure 15 on Page 53)

14-pin sealed

receptacle housing-
grey

Tyco/AMP

776273-4

SMART-AG mating connector

(Figure 15 on Page 53)

14-pin sealed

receptacle housing-
blue

Tyco/AMP

776273-5

Gold plated pins for SMART-AG
connector/loose

Pins, loose piece

Tyco/AMP

770854-3

Gold plated pins for SMART-AG
connector/strip

Pins, strip (reel)

Tyco/AMP

770520-3