Matrox Electronic Systems II ユーザーズマニュアル
88 Appendix B: Technical information Matrox Meteor-II /Standard
The mating connector included with the board is a 30-pin male,
0.050 pitch right angle connector. Parts for cables can be
purchased from:
0.050 pitch right angle connector. Parts for cables can be
purchased from:
This connector interfaces with a ribbon cable, 0.025 inch pitch
(0.635 mm), AWG #30 (solid wire).
(0.635 mm), AWG #30 (solid wire).
VMChannel interface connector
The VMChannel interface allows Matrox Meteor-II /Standard
to share data with any Matrox imaging board that has a
VMChannel interface capable of performing the bus controller
function. A VMChannel backplane (available with the
GEN-BUS/... interconnect kits) must be inserted across the
VMChannel interfaces of the boards.
to share data with any Matrox imaging board that has a
VMChannel interface capable of performing the bus controller
function. A VMChannel backplane (available with the
GEN-BUS/... interconnect kits) must be inserted across the
VMChannel interfaces of the boards.
Note the VMChannel is not supported on the CompactPCI and
PC/104-Plus form factors.
PC/104-Plus form factors.
The following table provides the pinout of the VMChannel
interface:
■
Manufacturer:
Fujitsu
■
Connector FCN-217J030-G/O
side view of board
pin 68
pin 35
(component side)
top view of board
pin 68
pin 34
pin 1
pin 35
(component side)
Pin
Signal
Pin
Signal
1
SAN
35
N/C*