Maxon Telecom Modem MM-6280IND ユーザーズマニュアル

 

 

HSDPA Standard At Commands        Page 12 of 60                             Version 1.2 

 

 

The following diagram shows the naming convention of messages between MT2 and TE2. 

Figure 1.  Naming convention diagram 

 

E<value> Mand. 

Command 

echo 

supported 

Q<value> 

Mand. 

Result code suppression 

supported 

S3 

Mand. 

Command line termination character 

supported 

S4 

Mand. 

Response formatting character 

supported 

S5 

Mand. 

Command line editing character  

supported 

V<value> 

Mand. 

DCE response format 

supported 

X<value> 

Mand. 

Result code selection and call progress monitoring control 

supported 

&C<value> 

Mand. 

Circuit 109 DCE RLSD (DCD) behavior 

supported 

&D<value> 

Mand. 

Circuit 108 DTE DTR behavior 

supported 

+IPR=<rate> Opt. 

Fixed Rm Rate. This numeric extended-format parameter 

specifies the data rate at which the MT2 will accept 

command set, in addition to 1200 bit/s or 9600 bit/s (as 

required in EIA/TIA-602). It may be used to select operation 

at rates at which the MT2 is not capable of automatically 

detecting the data rate being used by the TE2. 

115200bps. (Default) 

+IPR? Displays current set value. 

+IPR=? Displays range of (supported auto detectable rates), 

(list of supported fixed-only rates). e.g. +IPR: (1200, 2400, 

supported 

<TE2 sends command to MT2> 

Response (excluding AT) 

TE2 

MT2 

Command (including AT) 

<MT2 sends notification message to TE2> 

TE2 

MT2 

Notification (excluding AT) 

Indication (message) 

TE2 

MT2 

Signal (H/W) 

<MT2 sends H/W signalling to TE2>