Speed Queen AWNE82SP113TW01 インストール手順

TLW1975N_SVG

1.   Shipping Brace
2.   Shipping Plug
3.   Cardboard Base

Figure 2

Wipe Out Inside of Washtub

Prior to first wash, use an all purpose cleaner or a detergent
and water solution and a damp cloth to remove shipping dust
from inside of washtub.

TLW2009N_SVG

Figure 3

Connect Fill Hoses

WARNING

Under certain conditions, hydrogen gas may be pro-
duced in a hot water system that has not been used
for two weeks or more. HYDROGEN GAS IS EXPLO-
SIVE. If the hot water system has not been used for
such a period and before using the washer, turn on
all hot water faucets and let the water flow from each
for several minutes. This will release any accumulat-
ed hydrogen gas. The gas is flammable. Do not
smoke or use an open flame during this time.

W029

Mixing Valve Flow Rates

Pressure

psi [kPa]

HOT

gallons per
minute [liters
per minute]

COLD

gallons per
minute [liters
per minute]

WARM

gallons per
minute [liters
per minute]

20 [138]

3.4 [12.9]

4.0 [15.1]

120 [827]

4.6 [17.4]

Water Supply Requirements

Water supply faucets must fit standard 3/4 inch [19 mm] female
garden hose couplings. DO NOT USE SLIP-ON OR CLAMP-
ON CONNECTIONS.

NOTE: Water supply faucets should be readily accessi-
ble to permit turning them off when washer is not being
used.

Recommended cold water temperature is 50° to 75° Fahrenheit
[10° to 24° Celsius]. Recommended maximum hot water temper-
ature is 125° Fahrenheit [51° Celsius]. Warm water is a mixture
of hot and cold water. Warm water temperature is dependent
upon the water temperature and the pressure of both the hot and
cold water supply lines.

WARNING

To prevent personal injury, avoid contact with inlet
water temperatures higher than 125° Fahrenheit [51°
Celsius] and hot surfaces.

W748

Water pressure must be a minimum of 20 to a maximum of 120
pounds per square inch [minimum of 138 to a maximum of 827
kPa] static pressure measured at the faucet.

Installation

Part No. 202955R1