Speed Queen AWNE82SP113TW01 インストール手順
4. Tighten strap to hold hose to standpipe. This will prevent the
drain hose from dislodging from drain receptacle during use.
TLW2220N_SVG
5
6
4
3
2
1
1. Ribbed Portion of Drain Hose
2. Standpipe Adapter
3. Beaded Strap
4. Standpipe - 2 in. [51mm] or 1-1/2 in. [40 mm] Diameter
5. 36 in. [914 mm] Recommended Height
6. 12 in. [305 mm]
2. Standpipe Adapter
3. Beaded Strap
4. Standpipe - 2 in. [51mm] or 1-1/2 in. [40 mm] Diameter
5. 36 in. [914 mm] Recommended Height
6. 12 in. [305 mm]
Figure 5
Low Standpipe Installation
If standpipe is lower than 36 inches [914 mm], you must install
No. 562P3 Siphon Break Kit. Refer to Figure 6 . This kit is avail-
able (as optional equipment at extra cost) through an authorized
dealer or parts distributor. Installation instructions are supplied
with the kit.
No. 562P3 Siphon Break Kit. Refer to Figure 6 . This kit is avail-
able (as optional equipment at extra cost) through an authorized
dealer or parts distributor. Installation instructions are supplied
with the kit.
TLW2221N_SVG
2
1
3
1. 562P3 Siphon Break Kit
2. Standpipe
3. Drain Hose
2. Standpipe
3. Drain Hose
Figure 6
Wall Installation
For installations of this type, the drain hose MUST be secured to
one of the fill hoses using the beaded strap from accessories bag.
Refer to Figure 7 .
one of the fill hoses using the beaded strap from accessories bag.
Refer to Figure 7 .
NOTE: End of drain hose must not be below height of
cabinet top.
cabinet top.
W329I_SVG
2
1
1. Beaded Strap (tape if necessary)
2. Standpipe Adapter
2. Standpipe Adapter
Figure 7
Laundry Tub Installation
For this type of installation, the drain hose MUST be secured to
the stationary tub to prevent hose from disloding during use. Re-
fer to Figure 8 . Use the beaded strap (supplied in accessories
bag) to secure hose.
the stationary tub to prevent hose from disloding during use. Re-
fer to Figure 8 . Use the beaded strap (supplied in accessories
bag) to secure hose.
We recommend leaving the standpipe adapter on the drain hose
for this type of installation.
for this type of installation.
TLW2222N_SVG
1
1. Beaded Strap (tape if necessary)
Figure 8
Position and Level the Washer
1. Position washer so it has sufficient clearance for installation
and servicing.
2. Place washer in position on a clean, dry, and reasonably firm
floor. Installing the washer on any type of carpeting is not
recommended.
recommended.
3. For easier access to leveling legs, prop up washer with a
wooden block.
Installation
8
©
Copyright, Alliance Laundry Systems LLC - DO NOT COPY or TRANSMIT
Part No. 202955R1