KitchenAid KRMF706EBS 使用とお手入れ

■

To raise the drawer front, turn screw (B) counterclockwise. 

■

To lower the drawer front, turn screw (B) clockwise. 

6. Insert the Phillips screwdriver into screw (A), and turn 

clockwise to tighten the drawer front. 

7. Close the refrigerated drawer to check the alignment. Repeat 

steps 2 through 6 until the drawer fronts are level. 

IMPORTANT: Each refrigerated drawer can be adjusted side-to-
side on both the left and right side.   

1. With the drawers closed, identify the drawer that is not 

aligned.

2. Open the drawer to its full extension. Grasp the sides of 

the interior bin, and then lift it up and out to remove (see 
step 1 for further details).

3. Locate the drawer glide brackets (see step 1 for further 

details).

4. Starting with the glide bracket closest to the vertical gap, 

press and hold the release lever (C) up. With your other hand, 
lift the door clip (A) from the bracket (B). 

5. Reposition the clip (A) onto the glide bracket (B) in the 

direction you want to move the drawer front. Make sure that 
the glide bracket is vertically level. 

6. Release the lever (C) to lock the glide bracket into position.
7. Repeat steps 3 through 6 for the other side of the drawer 

front. 
NOTE: Adjust the clip (A) on the top of the second glide 
bracket (B) so that it is in the same position as the side you 
adjusted first

8. Close the drawer and visually inspect the gap. Repeat steps 

2 though 7 until the drawer fronts are aligned. 

1. Replace the interior drawer bins. 

NOTE: The bins must be placed into the drawers correctly, so 
that the refrigerated drawers will close and operate properly. 
See “Remove and Replace Drawer Fronts.”

2. Close the refrigerated drawers. 

Location Requirements

IMPORTANT: This refrigerator is designed for indoor, household 
use only.
To ensure proper ventilation for your refrigerator, allow for a 

¹⁄₂" (1.25 cm) of space on each side and at the top. Allow for a 

1" (2.54 cm) space behind the refrigerator. If your refrigerator has 
an ice maker, allow extra space at the back for the water line 
connections. When installing your refrigerator next to a fixed wall, 
leave a 3

³⁄₄" (9.5 cm) minimum space between the refrigerator and 

wall to allow the door to swing open.