KitchenAid KRMF706EBS 使用とお手入れ

1. Plug into a grounded 3 prong outlet.
2. Flush the water system. See “Water and Ice Dispensers.”
NOTE: Allow 24 hours to produce the first batch of ice. Discard 
the first three batches of ice produced. Allow 3 days to completely 
fill the ice storage bin. 

Handle Installation and Removal

Parts Included: Refrigerator door handles (2), Refrigerated 
drawer handles (2), Freezer drawer handle (1), 

³⁄₃₂" hex key, spare 

setscrew(s) 
NOTE: The freezer drawer handle is longer than the door handles. 
Handle style may vary by model.

NOTE: Handle mounting setscrews are preinstalled inside the 
handle.
1. Remove the handles from the packaging inside the 

refrigerator, and place them on a soft surface.

2. Open a refrigerator compartment door. On the closed door, 

place a handle onto the shoulder screws so that the setscrews 
are facing the adjacent door.

3. Firmly push the handle toward the door until the handle base 

is flush against the door. 

4. While holding the handle, insert the short end of the hex key 

into the upper hole and slightly rotate the hex key until it is 
engaged in the setscrew. 

5. Using a clockwise motion tighten the setscrew just until it 

begins to contact the shoulder screw. Do not fully tighten. 

6. Repeat steps 4 and 5 to fasten the lower setscrew.
7. Once both setscrews have been partially tightened as 

instructed in the previous steps, fully tighten both setscrews. 
IMPORTANT: When the screws feel tight, tighten them an 
additional quarter-turn. The handle is not properly installed 
without this extra tightening.

8. Repeat steps 2 through 7 to install the other handle onto the 

adjacent refrigerator door. 

1. With the drawer closed, place the handle onto the shoulder 

screws so that the setscrews are facing down toward the floor.

2. Firmly push the handle toward the drawer until the handle 

base is flush against the drawer.

A

B

A

B