KitchenAid KRMF706EBS 使用とお手入れ

 

6. While the compartment door is still open, lift the filter up into 

the compartment. Then, close the filter compartment door 
completely.

7. Flush the water system. See “Flushing the Water Filter” in the 

“Water and Ice Dispensers” section.
IMPORTANT: If you do not flush the water system, you may 
experience dripping and/or decreased flow from the water 
dispenser.

Press OPTIONS on the control panel to launch the Options menu. 
Press OPTIONS, under Filter Status, again to display the 
percentage of filter life remaining (from 99% to 0%). Press ICE/
WATER, under Back, to return to the Normal screen. 
The water filter status lights will help you know when to change 
your water filter. 

■

ORDER FILTER (yellow) - it is almost time to change the water 
filter. While you are dispensing water, “Order Filter” will blink 
seven times and sound an alert tone three times. 

■

REPLACE FILTER (red) - Replace the water filter. While you are 
dispensing water, “Replace Filter” will blink seven times and 
an alert tone will sound three times. 

■

RESET the water filter status tracking feature. After you 
replace the disposable filter with a new filter, closing the filter 
compartment door will automatically reset the filter status 
tracking feature. See “Using the Control(s).”

NOTE: “REPLACE FILTER” will remain illuminated if a filter is 
not installed or is installed incorrectly.

To purchase a replacement water filter, see “Accessories” in the 
User Guide, Use and Care Guide or User Instructions. 
Replace the disposable water filter when indicated on the water 
filter status display or at least every 6 months. If water flow to your 
dispenser or ice maker decreases noticeably, change the water 
filter sooner.   
1. Locate the water filter compartment in the right-hand side of 

the refrigerator ceiling. Push up to release and lower the 
compartment door. 

2. Turn the water filter counterclockwise (to the left), and pull it 

straight out of the compartment. 
NOTE: There may be some water in the filter. Some spilling 
may occur. Use a towel to wipe up any spills. 

3. Install the replacement water filter by following steps 2 

through 7 in the “Install the Water Filter” section. 

Install Air Filter 

(on some models)

An air filter is 15 times more powerful than baking soda at 
reducing common food odors inside the refrigerator. 
On some models, your refrigerator's accessory packet includes 
an air filter, which must be installed prior to use. 

Install the air filter behind the vented door, located on the rear wall 
near the top of the refrigerator compartment.
1. Remove the air filter from its packaging.
2. Lift open the vented door.
3. Snap the filter into place. 

The filter comes with a status indicator, which should be activated 
and installed at the same time the air filter is installed. 

1. Place the indicator face-down on a firm, flat surface.
2. Apply pressure to the bubble on the back of the indicator until 

the bubble pops to activate the indicator.

3. Lift open the vented air filter door. On some models, there are 

notches behind the door.
Models with notches:

■

With the indicator screen facing outward, slide the 
indicator down into the notches.

A