Continental Refrigerator Undercounter Refrigerator and Freezer Pizza Preparation Table ユーザーズマニュアル

ページ / 33
Important Note:
It is extremely important that your new model is perfectly
level for proper operation. If it is not level, the following adverse conditions will
become apparent:
1. The door(s) will not be properly aligned and consequently will not provide 
a good seal.
2. You model will run excessively due to improper door seal(s).
3. An excessive amount of ice will accumulate inside the cabinet, around the 
door opening(s) and especially on the finned evaporator coil. If allowed to 
continue, ice will eventually block the coil and the model will fail. This will 
result in the loss of all food stored within the cabinet.
4. Defrost water will fail to drain properly and will overflow the evaporator coil 
drain pan and into the cabinet of both refrigerator and freezer models.
INSTALLING CASTERS AND LEVELING
Your new “CRB” and “CPT” series models are supplied with non-adjustable casters. 
To install casters on your new model, follow the steps above for “installing legs” to
install the casters, making sure again that the casters are tightened extremely well
(see figure 3). If the casters are not installed tightly, the cabinet will sway or rock 
with each opening or closing of the doors, possibly causing damage to the case 
bottom.
To assure that your cabinet is level, caster cups must be installed under the casters
which need leveling. Caster cups are not provided with your new model but can be
purchased at most hardware or furniture stores. Do not attempt to level casters 
by unscrewing them from the case bottom as this will cause damage to the 
cabinet bottom and leg hole threads, voiding all warranties.
8