KitchenAid KFIS29PBMS ユーザーズマニュアル

REFRIGERATOR USE

IMPORTANT: To avoid low ice production and poor quality ice, 
flush the water system before turning on the ice maker. See 
“Water Dispenser.”

■

Allow 24 hours to produce the first batch of ice. Discard the 
first three batches of ice produced. Allow 2 to 3 days for the 
storage bin to fill completely following installation.

■

The quality of your ice will be only as good as the quality of 
the water supplied to your ice maker. Avoid connecting the 
ice maker to a softened water supply. Water softener 
chemicals (such as salt) can damage parts of the ice maker 
and lead to poor quality ice. If a softened water supply cannot 
be avoided, make sure the water softener is operating 
properly and is well maintained.

■

If the ice in the storage bin clumps together, break up ice 
using a plastic utensil and discard. Do not use anything sharp 
to break up the ice. This can cause damage to the ice bin and 
the dispenser mechanism.

■

Do not store anything in the ice storage bin.

■

The ice maker should produce approximately 3 lbs (1.4 kg) of 
ice per day under normal operation.

■

To increase ice production, select the increased ice 
production feature from the Options menu on the control 
panel. See “Using the Control(s).”

The ice maker is located on the left-hand side of the refrigerator 
compartment ceiling. Ice cubes are ejected into the ice storage 
bin, located on the left-hand refrigerator door.

 

1. Push up on the latch on the left-hand side of the ice 

compartment to open the door. 

2. Turn on the ice maker by moving the switch to the (left) ON 

position. 

NOTES: 

■

To manually turn off the ice maker, move the control to the 
OFF (right) position.

■

Your ice maker has an automatic shutoff. The sensor will 
automatically stop ice production if the storage bin is full, 
if the door is open or the storage bin is removed. The 
control will remain in the ON (left) position.

3. Close the ice compartment door.

■

Remove the ice storage bin by inserting your fingers into the 
hole at the base of the bin and squeezing the latch to release 
the bin from the compartment. Lift the storage bin up and pull 
it straight out. 

■

Replace the storage bin inside the ice compartment and push 
down to make sure it is firmly in place.

To turn the ice maker ON, simply lower the wire shutoff arm.

To manually turn the ice maker OFF, lift the wire shutoff arm to the 
OFF (arm up) position and listen for the click.

NOTE: Your ice maker has an automatic shutoff. As ice is made, 
the ice cubes will fill the ice storage bin and the ice cubes will 
raise the wire shutoff arm to the OFF (arm up) position. Do not 
force the wire shutoff arm up or down.

NOTE: Turn off the ice maker before removing the ice storage bin 
to serve ice or to clean the bin. This will keep the ice cubes from 
dropping out of the ice maker and into the freezer compartment. 
After replacing the ice storage bin, turn on the ice maker. 

A

A