Mitel 5 ユーザーズマニュアル

Single-Node and Network (Multi-Node) Configurations

Your system may be a stand-alone system (single node) or it may be connected to more than 
one node as a network (multi-node). In some cases, you can use the administrator phone to 
configure network node features. See “System Networks and Nodes” on page 5 for more 
information.

System Day and Night Modes

Day or Night Mode determines a system trunk access, toll restriction, emergency outgoing 
access, and related features for all phones on a node. Active calls are not affected when you 
switch to Day or Night Mode.

Setting a Single-Node System in Day or Night Mode

You can set the local node in Day or Night Mode. 

Dial 9860. 

NIGHT MODE IS ON (or OFF) appears

 followed by THE SYSTEM IS IN NIGHT 

MODE, if the system is in Night Mode. If the system is in Day Mode, the display returns to 
the idle state.

Selecting Nodes for Day or Night Mode

You can select system nodes for Day or Night Mode. 

Dial 9861. ENABLE NIGHT MODE ON NODE appears.

Enter the node number (01–99), or enter 00 to select all nodes (00 can also be used for a 
single-node configuration). ENABLED NETWORK NIGHT MODE appears, followed by 
THE SYSTEM (or NODE <number>)

 IS IN NIGHT MODE

.

Dial 9862. ENABLE DAY MODE ON NODE appears.

When prompted, enter the node number (01–99). To select all nodes or for a single-node 
configuration, enter 00. ENABLED NETWORK DAY MODE appears. The display then 
returns to the idle state.