Datalogic Scanning PD7100 사용자 설명서

Getting Started

This manual contains feature descriptions and barcodes which allow you to reconfigure your 
reader. Some programming barcode labels, like the 

Standard Product Default Settings on 

page 9

, require only the scan of that single label to enact the change. Most of the programming 

labels in this manual, however, require the reader to be placed in Programming Mode prior to 
scanning them. Scan an ENTER/EXIT barcode once to enterProgramming Mode. Once the 
reader is in Programming Mode, you can scan a number of parameter settings before scanning 
the ENTER/EXIT barcode a second time, which will then accept your changes, exit Program-
ming Mode and return the reader to normal operation.

Upon completing the physical connection between the reader and its host, proceed directly to 

Interfaces on page 11

 for information and programming for the interface type the reader is 

connected to (for example: RS-232, Keyboard Wedge, USB, etc.) and scan the appropriate bar-
code in that section to select your system’s correct interface type.

If after scanning the interface barcode from the 

Interfaces

 section, your installation requires 

you to select  options to further customize your reader, turn to the appropriate section for your 
interface type as listed below:

•

RS-232 ONLY Interface, starting on page 47

•

Keyboard Interface, starting on page 73

•

USB-OEM Interface, starting on page 87

•

IBM 46XX Interface, starting on page 89

If your installation requires different programming than the standard factory default settings, 
the following sections of this manual allow configuration of non-interface-specific settings you 
might require:

General Features

General Features includes programming for scanning, beeper and LED 

indicators and other such universal settings.

Symbologies

Includes options concerning the barcode label types (symbologies). These set-

tings allow you to enable/disable symbologies, set label lengths, require check digit, etc.