Siemens se5880 사용자 설명서

Easy Setup

This chapter describes how to define router configuration settings using the Easy Setup Wizard. These 
settings control access to the Wide Area Network (WAN) and Local Area Network (LAN). During the Easy 
Setup procedure, you will be prompted to specify configuration parameters that may require information from 
your service provider.

To access the Easy Setup Wizard, click Easy Setup in the left navigation pane of the Router Information 
window. This wizard will walk you through the configuration screens necessary to setup the router. You can 
exit the Easy Setup Wizard at anytime by clicking Cancel on the bottom of the configuration page. If the wizard 
is cancelled, no changes will be made and you will need to begin again. 

When you click Easy Setup in the 
left navigation pane of the Router 
Information page, the Untrusted 
Interface Configuration page is 
displayed. This page is used to 
enter information for the 
Untrusted (WAN-side) Ethernet 
Interface that will communicate 
with the Internet access device 
(for example, broadband modem 
or similar). Note that PPPoE IP 
Address and PPPoE IP Gateway 
are displayed only when Dial 
backup is enabled.

1. Select one of the following 

connection methods.

Using PPPoE:
Uses the Point-to-Point 
Protocol (PPP) to establish 
the connection. Refer to 

 for 

instructions on providing 
information on this page for this method.

Not Using PPPoE
Establishes the connection based on IP addressing. This option routes all IP packets for remote hosts to 
the WAN. Refer to 

 for instructions on providing information on this page for this 

method.