TP-LINK TL-SG3210 사용자 설명서

 

11

 

Now you can manage your switch with CLI commands through Telnet connection. 

You can refer to 

 for detailed commands information of the 

Telnet connection configuration. 

The CLI is divided into different command modes: User EXEC Mode, Privileged EXEC Mode, 

Global Configuration Mode, Interface Configuration Mode and VLAN Configuration Mode. 

Interface Configuration Mode can also be divided into Interface gigabitEthernet, Interface 

link-aggregation and some other modes, which is shown as the following diagram. 

The following table gives detailed information about the Accessing path, Prompt of each mode and 

how to exit the current mode and access the next mode. 

User EXEC 
Mode 

Primary mode once it 
is connected with the 
switch. 

Use the exit command to disconnect the 
switch (except that the switch is 
connected through the Console port). 
Use the enable command to access 
Privileged EXEC mode. 

Privileged 
EXEC Mode 

Use the enable 
command to enter this 
mode from User EXEC 
mode. 

TL-SG3424# 

Use the exit command to disconnect the 
switch (except that the switch is 
connected through the Console port). 
Enter the disable command to return to 
User EXEC mode. 
Enter  configure command to access 
Global Configuration mode. 

Global 
Configuration 
Mode 

Use the configure 
command to enter this 
mode from Privileged 
EXEC mode. 

Use the exit  or the end command or 
press  Ctrl+Z to return to Privileged 
EXEC mode. 
Use the interface  gigabitEthernet  port 
or  interface  range gigabitEthernet 
port-list command to access interface 
Configuration mode. 
Use the vlan  vlan-list to access VLAN 
Configuration mode. 

Interface 
Configuration 
Mode 

Use the interface 
gigabitEthernet  port 
or  interface  range 
gigabitEthernet 
port-list  command to 
enter this mode from 
Global Configuration 
mode. 

range)# 

Use the end  command or press Ctrl+Z 
to return to Privileged EXEC mode. 
Enter the exit  or  the  #  command to 
return to Global Configuration mode. 
A port number must be specified in the 
interface command.