TP-LINK TL-SG3210 사용자 설명서

 

73

 

dot1x port-control { auto | authorized-force | unauthorized-force }

 

auto | authorized-force | unauthorized-force —— The Control Mode for the port. 

auto:

In this mode, the port will normally work only after passing the 802.1X 

Authentication. 

authorized-force: In this mode, the port can work normally without passing the 

802.1X Authentication. 

unauthorized-force: In this mode, the port is forbidden working for its fixed 

unauthorized status. 

Interface Configuration Mode (interface gigabitEthernet / interface range 

gigabitEthernet) 

Configure the Control Mode for port 1 as authorized-force: 

TL-SG3424(config)# interface gigabitEthernet 1/0/1 

TL-SG3424(config-if)# dot1x port-control authorized-force 

The dot1x port-method command is used to configure the control type of IEEE 

802.1X for the specified port. By default, the control type is “mac-based”. To 

restore to the default configuration, please use no dot1x port-method 

command. 

dot1x port-method { mac-based | port-based } 

mac-based | port-based ——The control type for the port.   

Mac-based: Any client connected to the port should pass the 802.1X 

authentication for access.