TP-LINK TL-SG3210 사용자 설명서

 

74

 

port-based: All the clients connected to the port can access the network on the 

condition that any one of the clients has passed the 802.1X Authentication. 

Interface Configuration Mode (interface gigabitEthernet / interface range 

gigabitEthernet) 

Configure the Control Type for port 1 as port-based: 

TL-SG3424(config)# interface gigabitEthernet 1/0/1 

TL-SG3424(config-if)# dot1x port-method port-based 

The radius command is used to configure the parameters of radius. 

radius {[ auth-pri ip ] [ auth-sec ip ] [ auth-port port ] [ auth-key keyvalue ] 

[ acct-pri ip ] [ acct-sec ip ] [ acct-port port ] [ acct-key keyvalue ] [ timeout 

value ]} 

no radius { auth-port | auth-key | acct-port | acct-key | timeout } 

auth-pri ip —— The IP address of the authentication server. 

auth-sec ip —— The IP address of the alternative authentication server. 

auth-port port —— The UDP port of authentication server(s) ranging from 1 to 

65535. The default port is 1812. 

auth-key keyvalue —— The shared password for the switch and the 

authentication servers to exchange messages which contains 15 characters at 

most. 

acct-pri ip —— The IP address of the accounting server. 

acct-sec ip —— The IP address of the alternative accounting server. 

acct-port port —— The UDP port of accounting server(s) ranging from 1 to 

65535. The default port is 1813. 

acct-key keyvalue—— The shared password for the switch and the accounting 

servers to exchange messages which contains 15 characters at most.