Asante Technologies 8000 사용자 설명서
Installation and Setup
Page 2-8
Installing GBIC Interfaces
If you have installed Gigabit Ethernet switch modules, you must install
GBIC interfaces. Instructions for installing, removing, and maintaining
GBIC interfaces are provided in this section.
GBIC interfaces. Instructions for installing, removing, and maintaining
GBIC interfaces are provided in this section.
K
Note:
GBICs are hot-swappable.
Installing a GBIC
To install a GBIC interface into a Gigabit Ethernet module:
To install a GBIC interface into a Gigabit Ethernet module:
1
Remove the GBIC from its protective packaging.
2
Grip the sides of the GBIC with your thumb and forefin-
ger, then insert the GBIC into the slot on the front of the
Gigabit Ethernet module.
ger, then insert the GBIC into the slot on the front of the
Gigabit Ethernet module.
3
Slide the GBIC into the slot until you hear or feel a click.
The click indicates that the GBIC is locked into the slot.
The click indicates that the GBIC is locked into the slot.
4
When you are ready to attach the fiber-optic cable,
remove the plugs from the GBIC and save them for future
use.
remove the plugs from the GBIC and save them for future
use.
Removing a GBIC
To remove a GBIC interface from a Gigabit Ethernet module:
To remove a GBIC interface from a Gigabit Ethernet module:
1
Disconnect the fiber-optic cable from the GBIC SC-type
connector.
connector.
2
Release the GBIC from the slot by simultaneously
squeezing the plastic tabs on both sides of the GBIC.
squeezing the plastic tabs on both sides of the GBIC.
3
Slide the GBIC out of the slot.
4
Install the plugs in the GBIC optical bores, and place the
GBIC in protective packaging.
GBIC in protective packaging.