Asante Technologies 8000 사용자 설명서
Connecting Power
Page 2-9
GBIC Care and Handling
Follow these GBIC maintenance guidelines:
Follow these GBIC maintenance guidelines:
G
Unnecessary removal and insertion of a GBIC can lead to its pre-
mature failure. A GBIC has a lifetime of 100 to 500 removals/
insertions.
mature failure. A GBIC has a lifetime of 100 to 500 removals/
insertions.
G
GBICs are static-sensitive. To prevent ESD damage, follow your
normal board and component handling procedures.
normal board and component handling procedures.
G
GBICs are dust-sensitive. When the GBIC is stored or when a
fiber-optic cable is not plugged in, always keep plugs in the GBIC
optical bores.
fiber-optic cable is not plugged in, always keep plugs in the GBIC
optical bores.
G
Use an alcohol swab or Kim-Wipe to clean the ferrules of the opti-
cal connector. The most common source of contaminants in the
optical bores is debris picked up from the optical connectors.
cal connector. The most common source of contaminants in the
optical bores is debris picked up from the optical connectors.
Connecting Power
To connect power to the IntraCore 8000, use the following procedure.
I Important: Carefully review the power requirements on
page 2-1 before connecting power to the IntraCore 8000.
1
Plug one end of the supplied power cord into the power
connector on the back of the unit.
connector on the back of the unit.
2
Plug the other end into a grounded AC outlet.
The front panel LEDs blink and the Power LED illumi-
nates. The IntraCore 8000 is ready for connection to the
network.
nates. The IntraCore 8000 is ready for connection to the
network.
I Important: If the power does not come on, refer to
Appendix A, “Troubleshooting.”