Fujitsu N800 사용자 설명서

38

 

 U41243-J-Z156-1-76

Preparation for use and operation

Ê

Insert the ServerStart CD and keep ready the CD of the operating system 
you want to install.

Ê

Reboot the server.

Ê

Follow the instructions on the screen and in the manual for the operating 
system.

If your server is equipped with a disk array controller, please read in the appro-
priate manual how to configure the disk array before you install the desired 
system.

The configuration software and utilities supplied with the product make it easy 
for you to configure the server and its components (see the chapter “Configu-
ration software and utilities” on page 45).

The I/O board has a block of eight DIP switches (see figure 14 on page 40) for 
setting various configuration options (see the section “BIOS Setup” on 
page 47). Upon delivery, all the switches are set to the OFF position. table 2 
lists the functions of the various DIP switches:

1

OFF Normal 

Boot

The system attempts to boot using BIOS code from 
the flash memory.

ON

Recovery 
Boot

The system attempts a recovery boot by loading 
the BIOS code from a floppy disk into flash 
memory. This procedure is normally performed 
when BIOS code has been corrupted.

2

OFF No CMOS 

Clear

Preserves the contents of NVRAM.

ON

CMOS 
Clear

Replaces the contents of NVRAM with the default 
settings.

Table 2:  DIP switches settings