Cornelius 3 사용자 설명서

Viper Service Manual                                 

Publication Number: 621360041TBSER

- 54 -

© 2010, IMI Cornelius Inc.

The water pump is located just behind the water filter in the center of the unit. It 
is mounted on a bracket facing the rear of the unit. To replace the pump, perform 
the procedure in Table 47.

2

Remove the rear cover.

3

Disconnect the spade clips from the defective capacitor.

4

Remove the mounting screw from the base of the capacitor.

5

Replace the capacitor.

6

Reverse the procedure to install the new capacitor.

7

Reconnect power to the unit.

8

Refill the barrel with product. See “Filling a Barrel” on page 29.

9

When barrel fill is complete, perform a motor calibration. See “Calibrating a 

1

Disconnect power from the unit.

2

Remove the rear cover and the side panels.

3

Disconnect the CO

2

 supply from the unit.

4

Remove and drain the water supply from the unit.

5

Disconnect the quick disconnect input and output water lines from the bottom 

of the pump.

6

Disconnect quick disconnect CO

2

 input from the bottom of the pump.

7

Remove the four (4) screws and locknuts holding the pump to the mounting 

bracket.

8

Replace the pump.

9

Reverse the procedure to install the new pump.

Water Pump