ASKProxima impression 970 사용자 가이드
USER GUIDE
XGA LCD MULTIMEDIA PROJECTOR
34
11.3
LAMP REPLACEMENT MESSAGES
When the time is due to replace the lamp, the projector will give you one of
the two following messages on the screen.
the two following messages on the screen.
WARNING!
Lamp has less than 50 hours left of recommended burning time
Please change lamp!
Press any key to clear this message...
The lamp has only 50 hours burning time left, and should be changed.
Remember that you can check accumulated lamp usage each time the
projector is switched on. A message appears in the lower left hand corner
of the screen stating software revision and accumulated lamp hours used.
Remember that you can check accumulated lamp usage each time the
projector is switched on. A message appears in the lower left hand corner
of the screen stating software revision and accumulated lamp hours used.
If you do not respond to the first message, a second message will appear
when the lamp has exceeded recommended burning time. Please read
Warnings and Notes in Lamp Replacement section carefully and refer lamp
change to qualified service personnel only.
when the lamp has exceeded recommended burning time. Please read
Warnings and Notes in Lamp Replacement section carefully and refer lamp
change to qualified service personnel only.
WARNING!
Lamp has exceeded its lamp life of 750 hours
Continued use leads to a high risk of lamp explosion
PLEASE CHANGE LAMP IMMEDIATELY ! ! !
After the lamp has been replaced and the lamp timer has been reset, the
message below confirms that the operation has been successful.
message below confirms that the operation has been successful.
INFO!
The lamp timer has been reset to 0
Press any key to clear this message...