Cisco Cisco Web Security Appliance S360 릴리즈 노트

All AsyncOS versions that did not include ISE support (that is, all versions prior to 8.5.0-497), and the 
limited-availability AsyncOS 8.5 “ISE Preview” release, did not require the Admin and pxGrid 
certificates, which are necessary in all Cisco AsyncOS releases that include ISE support. Therefore, 
when you upgrade from a non-ISE release, or from an ISE Preview installation with ISE enabled, the 
ISE feature will not operate correctly until the two additional certificates are provided (go to Network 
> Identity Services Engine).

For compatibility between this release and AsyncOS for Cisco Content Security Management releases, 
see the compatibility matrix at: 

When the appliance is configured in Cloud Connector mode, unavailable options for IPv6 addresses and 
Kerberos authentication appear on pages of the web interface. Although the options appear to be 
available, they are not supported in Cloud Connector mode. Do not attempt to configure the appliance 
to use IPv6 addresses or Kerberos authentication when in Cloud Connector mode.

Command line and web interfaces. You can access WSA using http://[2001:2:2::8]:8080 or 
https://[2001:2:2::8]:8443

Performing Proxy actions on IPv6 data traffic (HTTP/HTTPS/SOCKS/FTP)

IPv6 DNS Servers

WCCP 2.01 (Cat6K Switch) and Layer 4 transparent redirection