GE 28031 series 사용자 설명서

38

A long warbling tone (with ringer on) 

Signals an incoming call

Three short beeps 

Page signal

One long beep 

Confirmation tone for the 

 

completion of a function

One short beep 

Ring alert tone 

(during room monitoring mode)
One short beep (every 7 seconds) 

Low battery warning

No dial tone

•  Check and repeat installation steps:
  Ensure the base power cord is connected to a working electrical 

outlet .

  Ensure the telephone line cord is connected to the base and the wall 

jack.

•  Connect another phone to the same jack; if there is still no dial tone, 

the problem might be your wiring or local service.

•  The handset may be out of range of the base. Move closer to the 

base.

•  Ensure the battery is properly charged (16 hours).
•  Ensure the battery pack is installed correctly. 
•  The handset should beep when you press the TALK/CALL BACK 

button and the charge indicator on the base should be lit when 

the handset rests in the cradle. If not, the battery may need to be 

charged.

•  Place handset in charge cradle for at least 0 seconds to reset the 

unit.

Handset does not ring  

•  Make sure the handset ringer switch is turned ON, this can be done 

through the handset setup menu - Ringer Volume.

•  The handset may be out of range. Move closer to the base.
•  You may have enabled Do Not Disturb (DND). Make sure the DND is 

off.

•  You may have too many extension phones on your line. Try 

unplugging some phones.

•  Check for dial tone.