GE 28031 series 사용자 설명서

39

You experience static, noise, or fading in and out

•  The handset may be out of range of the base. Move closer to the 

base.

•  Make sure base is not plugged into an outlet with another household 

appliance. If necessary, relocate the base.

•  Charge the battery.

Unit beeps

•  Clean charging contacts on cordless handset.
•  See solutions for “No dial tone”.
•  Replace the battery.

Memory Dialing doesn’t work

•  Did you program the memory location keys correctly?
•  Did you follow proper dialing sequence? 

Unit locks up and there is no communication between the base and 

cordless handset

•  Unplug the AC power adaptor from the wall outlet and the back of 

the base. Remove the handset battery. Wait for 30 seconds and plug 

the power adaptor back into the base and wall outlet. Reconnect the 

battery and charge for 16 hours.

Handset displays "SEARCHING" or "OUT OF RANGE" and cannot link up 

with the base when the TALK/CALL BACK button is pressed.

•  Handset may be out of range of the base. Move closer to the base.
•  Make sure the power adaptor is properly installed.
•  Disconnect the handset battery and plug it in again. Place the 

handset on the cradle for at least  to 3 minutes.

•  Disconnect the power adaptor and plug it in again. Then place the 

handset on the cradle for at least  to 3 minutes.

Handset displays "HANDSET NEEDS REGISTRATION" 

•  Follow the programming in the telephone procedures to re-register 

the handset to the base.

•  Press the SELECT button to begin handset registration. Follow 

instructions on handset screen.

No Display

•  Charge the battery (for 16 hours). Or replace the battery.
•  Make sure that the unit is connected to a non-switched electrical 

outlet. Disconnect the AC power adaptor from the base and 

reconnect it.