honda-automobiles hrx217hxa 사용자 설명서

5

Adjust handlebar height for a comfortable operating position (page 3). 

Adjust the Clip Director knob in any one of the ten positions to achieve 
the desired mowing results.

To adjust the Clip Director knob, pull the knob downward and towards 
the rear of the mower. The knob adjusts a sliding door from the fully 
open BAG position to the fully closed MULCH position.    

Always turn the engine off, remove the key (HRX217HMA only), and 
disconnect the spark plug cap (page 12) before lifting the discharge 
guard to view or clean around the sliding door. This will prevent 
contact with the rotating blades and prevent objects from being 
thrown into the discharge area.

Some grass accumulation in the discharge opening is normal when 
the Clip Director is fully closed. To remove this grass, close the 
discharge guard, fully open the Clip Director, start the engine, and 
engage the blade control lever several times.

If a high resistance is noticed when moving the Clip Director knob 
from side-to-side, excessive grass may have built up on top of the 
sliding door.

The sliding door can be positioned to produce different mowing 
results. If the preferred sliding door position is unknown, install a 
grass bag and begin mowing with the Clip Director knob all the way to 
the BAG position. Check the appearance of the lawn. As the knob is 
moved towards the MULCH position, more grass will be recycled back 
into the lawn. Adjust the Clip Director knob until the desired result is 
achieved. 

To discharge clippings to the rear, remove the grass bag and position 
the Clip Director knob in the BAG range. Maximum rear discharge will 
occur when the Clip Director knob is all the way to the left (BAG) 
position. As the Clip Director knob is moved toward the right (MULCH) 
position, less grass will be discharged through the rear discharge 
guard.

Use the Clip Director to shred and collect fallen leaves for disposal. 
Set the front wheels so they are one or two settings higher than the 
rear. Set the Clip Director in position #9 (not quite full mulching) and 
adjust the setting from this point for best results.