honda-automobiles fs5047 사용자 설명서
OPERATION
OPERATING CONTROLS
1.
. RAISING AND LOWERING THE ROTARY BROOM
LOCK
Refer to 'control' section of quick
hitch
operator's manual (HTA Model QH5000)
page 5.
page 5.
2.
STARTING AND STOPPING THE ROTARY BROW
Refer to tractor operator's manual for
proper front "PTO" operation.
ADJUSTMENTS (FIGURE 1)
Before making any adjustments,
stop
the broom by moving the clutch lever
rearward, stop the engine
, set the parking
brake and remove ignition key.
1.
BROOM ANGLE ADJUSTMENT (1)
With
broom raised to transport
position, carefully lift angle
adjustment lever (1 , select angle
12.5
o
or
25
o
either side), release
lever and make
sure broom is locked
at desired angle.
2. BRUSH TO GROUND
CONTACT ADJUSTMENT
To
increase brush to ground contact,
turn knob
(2) counter-clockwise. To
decrease brush to ground contact,
turn knob (2) in a clockwise
direction.
Use only to compensate
brush wear.
NOTICE
Adjust so that broom head
when lifted by the front , weighs
between 30 - 50 lbs (13.5 kg.-
between 30 - 50 lbs (13.5 kg.-
22.6 kg.). More than this can cause
premature brush wear and overheat
gearbox.
FIGURE 1
3.
FRONT WHEEL JACK (3)
Pull
knob completely outward to
reach approximate height adjustment.
Pull knob halfway and turn knob 1/4
turn at a time to reach final height.
turn at a time to reach final height.
4. PARKING STANDS (4)
Always
use stands when broom is not
in
use to prevent brush deformation.
5
OPTIONAL CASTER WHEELS ADJUSTMENT (5)
Required for lawn thatching or leaf
raking. Height is adjusted to the
nearest
1/4" by placing spacer sleeve(s)
on upper or lower side of stand support.
Adjust casters at
Adjust casters at
1"-1 1/4" below brush
tips
(see next page for applications).
6. SIDE TO SIDE LEVEL ADJUSTMENT
With
the broom raised to transport
position, loosen the three bolts
(6), place broom level and tighten
the bolts (6) securely.
OM 0180
9