Microboards Technology hcl-6000 사용자 설명서

 

Microboards B.30 
1. Copy         (MM) 

Microboards B.30 
6. Select Burn Speed 

HDD to CD Speed 
32x 

Select Burn Speed 
HDD to CD Speed

 

With the Test + Copy menu option, the autoloader simulates the copying process, and then makes copies if 
everything works correctly. If a failure is encountered on a disc during the simulation, it will not be copied 
during the copying process while the discs that passed the simulation will move on to the copying process. 
After the copying process, the

 

autoloader will place the failure discs into the reject

 

area while the successfully 

copied discs will be placed into the corresponding Output Spindle. 
 
Operation in Test+Copy menu is identical to operation in Copy menu.  
 

The  Copy + Compare menu option is used to make verified copies. After the copy process is done, the 
autoloader automatically compares the copies to the master content residing in the hard drive to ensure that 
they are identical. When the operation is complete, the autoloader automatically places good discs on to the 
Output Spindle and bad discs in the Reject Area.  

Operation in Copy+Compare menu is identical to operation in Copy menu.  
 

The Select Burn Speed menu option is used to adjust the duplication speed for the various duplication modes. 
By default, the duplication speed will be set to the optimal speed. However, under some circumstances you 
might want to lower the duplication speed. Those circumstances are:  

¾  Poor Blank Media Quality - When your media quality is sub-par, lowering the duplication speed is 

necessary to make good copies.  

¾  Duplication Quality - Overall, the lower the speed, the higher the quality of your duplicates. If you 

have time, it is a good choice to lower the speed to produce the best quality duplicates.  

If you are at the 1. Copy Menu, do the following: 

 
Use the   Up or   Down button to find the 6. Select Burn Speed  menu.  
 
 
Press the   OK button on 6. Select Burn Speed menu to set the duplication 
burn speed and you will see the Select Burn Speed type menu similar to 
below:  
 
There are two recording speed types that can be set:  

¾  HDD to CD: Copy Hard Drive CD Content to CD-R/RW Discs speed.  
¾  HDD to DVD: Copy Hard Drive DVD Content to DVD±R/RW Discs.  

Depending upon the type of duplication and your autoloader restrictions, you need to select the correct format 
in order to take effect. To select the recording speed options, use the   Up or    Down buttons to find the 
desired speed for the appropriate format and press the    OK button to enter the menu. You will see a menu 
similar to this:  

 
Use the   Up or   Down button to find the desired speed. Press the   OK 
button to set the desired recording speed. 
 

The options that are available are shown in Table 2-1.  
 

Duplication Type  

Speeds Available  

HDD to CD 
Speed  

1x, 2x, 4x, 8x, 12x, 16x, 24x, 32x, 40x, 48x, 
52x  

HDD to DVD 
Speed  

1x, 2x, 2.4x, 4x, 6x, 8x, 12x, 16x  

These options might change depending on the CD or DVD writers pre-installed in your system.  

Note: The speed that you choose may be adjusted by the drives and/or the media for optimized 
duplication.