Xircom EAG2919 사용자 설명서
Eagle II GSM Radio Module Technical Manual Preliminary Draft: 08/31/00
29
Part Number: 07100017 version 00.04
© 2000 Xircom, Inc. All rights reserved.
All trademarks and copyrights are the property of Xircom, Inc.
All trademarks and copyrights are the property of Xircom, Inc.
Sending an Initialization String to the Eagle II Module
The following example provides the sample AT commands and responses for the
following initialization tasks:
following initialization tasks:
!
Reset the module to the factory defaults
!
Enable character echo
!
Set the module to Verbose mode (to display result codes as words)
!
Set the DCD to ON
!
Monitor the DTR
App > Eagle
AT& FE0Q0V1&C1&D2
Initialization string
Eagle > App
OK
Command is valid
App > Eagle
ATSO=1
Auto answer on 1st ring
Eagle > App
OK
Command is valid
Setting Up the Communication Mode for the Eagle II Module
The following example provides the AT command and response for setting the Eagle II
module for 9600 baud, non-transparent mode.
module for 9600 baud, non-transparent mode.
App > Eagle
AT+CBST=7,0,1
9600 baud, non-transparent mode
Eagle > App
OK
Command is valid
Querying the Status of the Eagle II Module
The following examples provide the AT commands and responses for querying the status
of the unit. For more information about the commands and response codes, see the
Eagle II Programmer's Manual.
of the unit. For more information about the commands and response codes, see the
Eagle II Programmer's Manual.
!
The following command checks to determine if the Eagle II module has successfully
registered with the GSM network.
registered with the GSM network.
App > Eagle
AT+CREG?
Get the registration status
Eagle > App
+CREG: 0,1
OK
Registered with home network
+CREG=0,2 registration in progress
+CREG=0,5 registered as roaming