TP-LINK TD-W8920G 사용자 설명서

default value 2347 is recommended. If a network packet is smaller than the preset RTS 

threshold size, the RTS/CTS mechanism will not be enabled. The Router sends Request to 

Send (RTS) frames to a particular receiving station and negotiates the sending of a data 

frame. After receiving an RTS, the wireless station responds with a Clear to Send (CTS) 

frame to acknowledge the right to begin transmission. In most cases, keep its default value 

of 2347. 

¾  DTIM Interval: This value, between 1 and 255, indicates the interval of the Delivery Traffic 

Indication Message (DTIM). A DTIM field is a countdown field informing clients of the next 

window for listening to broadcast and multicast messages. When the Router has buffered 

broadcast or multicast messages for associated clients, it sends the next DTIM with a DTIM 

Interval value. Its clients hear the beacons and awaken to receive the broadcast and 

multicast messages. The default value is 1. 

¾  Beacon Interval: Enter a value between 20-1000 milliseconds. The Beacon Interval value 

indicates the frequency interval of the beacon. A beacon is a packet broadcast by the Router 

to synchronize the wireless network. The default value is 100. 

¾  Mode: In the drop-down list you can select “11Mbps (802.11b)”, “54Mbps (802.11g)”, and 

“108Mbps (Dynamic)”. "54Mbps (802.11g)", which allows both 802.11g and 802.11b 

wireless stations to connect to the Router, “108Mbps (Dynamic)” allows Super G

™

, 802.11g 

and 802.11b wireless stations connect to the router. 

Choose “Wireless”

Æ”Statistics”, you will see the screen of Wireless-Statistics setting shown as 

below. 

 

Figure 5-62 

This page shows authenticated wireless stations and their status. 
¾  BSSID: Displays the connected wireless station's MAC address. 
¾  Associated: Displays whether the wireless station has associated with the access point. 
¾  Authorized: Displays the information of Authentication. 

 68