Apricorn Aegis Bio USB3.0 500GB A25-3BIO256-500 사용자 설명서

To lock the Aegis Bio after it has been unlocked, use the directions below.

Press the ENROLL button until the 

 LED turns on.

 The drive 

will check for disk activity. If no data has been written to the drive for 2 

seconds, the drive will lock. If data is being written to the drive, it will wait 

until the disk activity has been finished before locking the drive.

2. 

The Aegis Bio LED will go from 

 to Solid 

 when locked.

NOTE: If you use the safely remove hardware button (Windows) or 

Eject device (Mac), the Aegis Bio will lock and dismount but the LED 

will remain 

. You will need to physically remove and re-plug the 

USB cable before being able to access the drive.

Once your fingerprints are enrolled, you can unlock the Aegis Bio using the 

directions below.

1. 

Attach the integrated USB cable of the Aegis Bio to an available 

USB port on your computer. The Aegis Bio LED will show Solid 

 

indicating that the drive is locked and is in Standby mode.

Swipe your Finger. The 

 LED will turn off while the 

 LED will 

start to flicker briefly as the Aegis Bio processes your fingerprint.

3. 

You will know that your fingerprint has been accepted once the 

 

LED stops flickering and turns Solid 

. 

1. 

Hold down the ENROLL button and plug the Aegis Bio USB cable into 

your computer. The LED will alternate 

 / 

.

2. 

Release the ENROLL button, then within 5 seconds repress and hold the 

ENROLL button for 15 seconds. The LED will alternate between 

 / 

 / 

 during the 15 seconds.

3. 

When the drive successfully resets, the 

 LED will stay on for 3 

seconds, then will change to Solid 

 with the 

 LED flashing. 

You can now release the ENROLL button.

4. 

The Aegis Bio has now been returned to its 

OUT OF THE BOX state 

and is now ready to enroll fingerprints. Once fingerprints are enrolled 

the Aegis Bio will need to be partitioned and reformatted before use.