Apricorn Aegis Bio USB3.0 500GB A25-3BIO256-500 사용자 설명서

If there are less than 5 fingerprints enrolled and you want to enroll a new finger, 

follow the instructions below.

Plug in the Aegis Bio to a USB port on your computer. The LED should 

be Solid 

 indicating that the drive is Standby mode.

If less than 5 fingerprints are enrolled, the 

 LED will become Solid 

 and 

 LED will remain illuminated. Proceed to Step 3.

If 5 fingerprints are enrolled, the 

 and 

 LED will come on for 2 

seconds and the 

 LED will be Solid 

. You will not be able to enroll 

any more fingerprints.

Swipe a finger that has been previously enrolled. The 

 LED will 

flash if the fingerprint is accepted. If the fingerprint is not accepted the 

 

LED will flash.

4. 

Once the fingerprint is accepted the 

 LED will become Solid 

 and 

the 

 LED will continue flashing, indicating that the Aegis Bio is ready 

to enroll a new fingerprint.

Swipe a new finger. The 

 LED will turn off while the 

 LED 

starts to flicker briefly as the Aegis Bio processes your new fingerprint.

Wait until the 

 LED turns back to Solid 

 and the 

 LED 

returns to its flashing state.

Repeat Step 5 until both the 

 and 

 LED are in a solid state, 

indicating that your fingerprint is fully enrolled.

Apricorn provides the following helpful resources for you:
 

1.  Apricorn’s Website (

http://www.apricorn.com)

This gives you the ability to check for up-to-date information

 

2.  E-mail us at 

 

3.  Or call the Technical Support Department at 

Apricorn’s Technical Support Specialists are available from 8:00 a.m. to 
5:00 p.m., Pacific Standard Time Monday through Friday